Питание дома или объекта без подключения к электросети.
Why it matters for home backup power
Most homes treat a battery as a buffer: the grid is the normal power source and the battery steps in only during outages. Off-grid removes the grid connection entirely. It is the right design for remote sites the utility has never reached, for buildings where running a grid line is not practical, and increasingly for owners who want full independence from utility pricing and outage schedules.
In Ukraine, where extended power cuts are a daily planning factor in many regions, the question comes up often: can a backup system run indefinitely without the grid? A true off-grid system can. A grid-backup system designed only to bridge short gaps cannot, because its battery bank and charge source are sized for the critical loads only, not the total home demand.
Off-grid in practice
Key numbers
Sizing an off-grid system starts from the full daily energy demand, not just the critical loads. Genixgreen LiFePO4 systems run at a nominal 51.2 V and are rated for 6000+ cycles, scaling in parallel from about 5 kWh to 16 kWh for homes and into the MWh range for commercial sites. For planning purposes, usable energy is about 85 percent of nameplate capacity, reflecting depth of discharge of 80 to 95 percent and one-way inverter efficiency of 90 to 95 percent(Source: Battery University BU-808). Runtime in any real installation depends entirely on the connected load.
Off-grid vs. grid-backup
A grid-backup system keeps the grid as the primary charge source and falls back to the battery during outages. An off-grid system has no grid connection at all: solar panels, a wind turbine, or a generator is the charge source, and the battery plus inverter handle all loads continuously. The practical difference is scale: off-grid demands a battery bank, charge source, and inverter all sized to the full daily load, not the critical subset.
How Genixgreen uses off-grid
Genixgreen has built LiFePO4 storage in its own factory since 2011 and ships to 100+ countries, with local stock in Odesa for delivery across Ukraine. The same 51.2 V LiFePO4 modules used in grid-backup installations work in off-grid configurations; parallel expansion lets a site add capacity as its generation or load grows without replacing the battery bank.
Related terms
- Гибридный инвертор: manages power flow between generation source, battery, and loads in an off-grid or hybrid setup
- ESS (система накопления энергии): the battery bank and management electronics that form the core of any off-grid installation
- Критические нагрузки: the priority circuits that must stay on, whether the system is off-grid or running in backup mode
- Автономный режим: the disconnected operating state an off-grid system runs in permanently, with no utility grid present
- Сетевой режим (grid-tie): the opposite mode, where the system stays synchronized with and connected to the utility grid
- Browse the full Genixgreen energy storage glossary
- See the complete system range on our product page